Can-Am ATV & UTV Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,899 Posts
Discussion Starter · #1 ·
while i'm getting materials to make a primary tool for inner clutch, i decided to take the main bolt that goes thru both pieces and thread it in and it starts to thread then stops. Not sure how it suppose to thread in, almost feels like it might be x-threaded? Just wondering if it might be cross threaded or i may have an issue with the shaft? on the videos i've seen, a torque wrench is used, i was just trying by hand at first. tks
 
1 - 1 of 1 Posts
Top