Can-Am ATV & UTV Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Have a 2019 can am outlander XMR. One day while riding check engine light flashes and then just shut off saying high temp limp home mode. Able to get it started again to ride back to starting point. Took off right side panel and noticed the coolant tube going into the engine came off. Got a new clamp and reconnected it and filled back up with coolant. Let it run for about ten mins and the same messages came back up.
I didn’t notice any coolant leaks but did notice that the reservoir tank is empty. I can not add anymore coolant. Can not figure out why not coolant is going into the reservoir tank but the tubes are full
 

·
Super Moderator
Joined
·
2,913 Posts
The motor has 2x bleed screws, as previously stated, that you need to crack open to let the air bleed from the cylinder heads.
#21 in the pic shows their location.
Don't over tighten them and check the sealing washers for splits.

White Gesture Font Auto part Art
 
1 - 3 of 3 Posts
Top