Can-Am ATV & UTV Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
2013 commander 1000 with 800 miles on it. oil or gear box leak not sure. i took off both side engine panels and the bottom skid panels. used degreaser and cleaned the bottom pan where the oil was congregating. Let sit for 4 days... not a drip, pan dry. went for a 1/2 hour ride park it... next morning oil in the pan just starting to drip. As near as i can tell the oil is near the front of the engine. i have checked the oil drain plug, oil filter cap, gear box drain plug, front and rear output shaft seals seem dry. What the hell could it be... I guess this weekend I will pull the belt covers off and see if those seals are leaking. For the life of me i cant figure this out. I hope like ever i can resolve this before I have to go to the dealer.
 

·
Registered
Joined
·
152 Posts
Could be case half seals.

Crank seal (under the clutch) or trans seal (behind secondary clutch). But usually those only leak in the belt housing.

There is also the O-Ring where engine and trans bolt together......3 dollar part and its fin to change!!

Thats what Ive seen with Can Am.
 
1 - 2 of 2 Posts
Top