Can-Am ATV & UTV Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I'm having a problem with me ignition switch in the light position and no lights or power to the winch. Also the check engine light comes on. When I move to the next position the engine light goes off and the winch works. Any ideas where to start? Already checked all fusses.

Sent from my iPhone using Tapatalk
 

·
Super Moderator
Joined
·
2,960 Posts
Try spraying some WD40 into the switch first. This usually helps the chip in the key register with the ecu.

If you wind up replacing the switch, it's simply a matter of changing it out. No reprogramming needed.
 

·
Super Moderator
Joined
·
8,708 Posts
just a heads up, my dealer had mentioned the weak contacts in the key switch. so leave the key on and use the kill switch to shutoff the bike to stop future trouble
My key almost never comes out of the ignition switch.
 

·
Registered
Joined
·
2 Posts
I'm having a problem with my ignition switch when turned off i still showing power to dash and clusters. engine does shut down. i have a kill switch though and when turned off and back on again everything seems fine. any thoughts?
 
1 - 9 of 9 Posts
Top