Can-Am ATV & UTV Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Trying to see anyone here has a 2014 or a Can-Am that has the plate around the carburetor where you can't even get to the screws on the bottom of the bowl I believe I need to take the carburetor off and clean the Jets because it idles and I could wrap it up a little bit but it will bog out and there is no power when I put it in gear and try to drive it it doesn't go anywhere and it dies I took the screen out the back of the muffler clean that out I can see through it so I think it's clean I put it back on I checked the spark plug it was dirty I seen that put it back on and I checked the air filter and I even pulled the filter part out it seemed like it ran a little better but it still bogged down and have no power also need to know how to adjust the chain on the back correctly
 
1 - 1 of 1 Posts
Top