[johnwbelding]

I had to replace the starter clutch on the Traxter and when I pulled the engine I missed detaching the ignition coil wiring harness and pulled the plug assembly off of the coil. The coil tested fine, but I have no spark. I have checked the fuses, and the unit had spark before I screwed up. Is there source for a wiring diagram for that model or can someone tell me what that wires go to? There is a green, a green and white, and a black wire to the coil. One of the green wires is hot with the ignition on. The over two are not hot and the black one does not test as a ground. Any help would be appreciated.

 

[ozymax]

Any help to you?
The WH/GN-16 wire runs to the ignition fuse.
Double check your wire colours.
According to this diagram you should have a white/green (ign). A black/green for spark 1 and a green/black for spark 2.

 

[johnwbelding]

Thank you for the diagram. You are probably right on the colors. It is pretty dirty and hard to see down in there. I did find 12 volts on the Green/white wire. Is there a way to test the black/green and green/black terminals with a voltmeter? Would those flash 12 volts as the engine was turning over?

 

[ozymax]

I've sent you a PM.