Anyone remove the rear driveshaft without taking the diff out. Was wondering if there is enough room if you unbolt it and slide it back.
2 replies to this topic
#1
stovepiper
-
- Moderators
-
- 341 posts
Advanced Member
- Gender:Male
- Location:Chilliwack BC
- Interests:Anything with gas or gun powder
- Your Ride:outlander 1000 xt cammo qsc primary,stm secondary, THE BOM supermag cams, muzzy exhaust, flashed ecu by monster, monster fuel tuner,51mm throttle body and a grin like I ate a banana sideways.
Posted 01 November 2020 - 10:44 AM
#2
2000hdflstf
-
- Members
-
- 13 posts
Member
- Your Ride:2014 Can-am Outlander Max 1000
Posted 26 March 2021 - 02:06 PM
Yes... you can take the thru bolts out and side it back without taking the axles and everything apart. Did my sons13 1000 rene, and my 16 1000 outlander max.
Sent from my SM-G930R4 using Tapatalk
Sent from my SM-G930R4 using Tapatalk
#3
stovepiper
-
- Moderators
-
- 341 posts
Advanced Member
- Gender:Male
- Location:Chilliwack BC
- Interests:Anything with gas or gun powder
- Your Ride:outlander 1000 xt cammo qsc primary,stm secondary, THE BOM supermag cams, muzzy exhaust, flashed ecu by monster, monster fuel tuner,51mm throttle body and a grin like I ate a banana sideways.
Posted 28 March 2021 - 11:22 AM
Much appreciated, Put a new diff in and noticed a wobble in my shaft even with new u joints. Was hoping not to have to remove the whole works again.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
